Escape 2WD L4-2.3L VIN Z (2005)
Removal and Installation
1. Recover the refrigerant.
2. Loosen the nut and disconnect the evaporator inlet line fitting.
-
Remove and discard the O-ring.
-
To install, tighten to 10 Nm (89 lb-in).
3. Disconnect the orifice evaporator inlet line spring lock coupling and remove the orifice evaporator inlet line.
4. NOTE: New O-ring seals, lubricated in clean mineral oil, must be installed before reconnecting any A/C fitting which has been disconnected.
To install, reverse the removal procedure.
-
Charge and leak test the refrigerant system.