Escape 2WD L4-2.3L VIN Z (2005)
Catalytic Converter: Service and Repair
Catalytic Converter
Catalytic Converter
Removal and Installation
NOTE: Do not use oil or grease-based lubricants on the insulators. They may cause deterioration of the rubber.
NOTE: Oil or grease-based lubricants on the insulators may cause the exhaust hanger insulator to separate from the exhaust hanger bracket during
vehicle operation.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove and discard the 2 exhaust catalytic converter nuts.
^
To install tighten to 47 Nm (35 ft. lbs.).
3. Remove and discard the U-bolt clamp assembly from the muffler.
^
To install, tighten to 47 Nm (35 ft. lbs.).
4. Remove and discard the 2 resonator nuts.
^
To install, tighten to 47 Nm (35 ft. lbs.).
5. Remove and discard the catalytic converter exhaust hanger.
6. Remove the exhaust catalytic converter and the muffler from the vehicle as an assembly.
7. Separate the converter from the muffler.
8. To install, reverse the removal procedure.
^
Install new gaskets.
