Escape 2WD L4-2.3L VIN Z (2005)
6. Disconnect the generator electrical connector.
7. Remove the generator lower air duct bolt.
-
To install, tighten to 4 Nm (35 lb-in).
8. Press the locking tab to release the generator lower air duct from the generator and remove the lower air duct.
9. Remove the pin-type retainer from the bottom of the generator shield.
10. Remove the generator shield nut and the generator shield.
-
To install, tighten to 20 Nm (15 lb-ft).
11. Remove the generator stud nut.
-
To install, tighten to 47 Nm (35 lb-ft).
12. Remove the generator stud.
-
To install, tighten to 24 Nm (18 lb-ft).
13. Remove the 2 generator bolts and the generator.
-
To install, tighten to 47 Nm (35 lb-ft).
14. To install, reverse the removal procedure.
