Escape 2WD L4-2.3L VIN Z (2005)
3. NOTE: This step may not be necessary if the inner wheel bearing race remains in the wheel knuckle after removing the wheel hub.
Using the special tool, press the inner wheel bearing race from the wheel hub.
4. Remove the snap ring.
5. Using the special tools, press the outer wheel bearing race from the wheel knuckle.
Installation
1. Position the wheel knuckle in a vise.
2. NOTE: Special Tool 205-278 is not seen in place. It is located behind the wheel knuckle.
Using the special tools, install the wheel bearing into the wheel knuckle.
3. Install the snap ring.
4. Using the special tool, press the wheel hub into the wheel bearing.
5. Install the wheel knuckle.
