Escape 2WD L4-2.3L VIN Z (2005)
Windshield Washer Pump: Service and Repair
Rear Window Washer Pump
REAR WINDOW WASHER PUMP
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the RH front fender splash shield.
3. WARNING: Windshield washer solution contains methanol, which is poisonous. Observe all cautions and warnings indicated on the
label of the washer solution container. Failure to follow these instructions may result in personal injury.
CAUTION: When replacing the rear window washer pump, be careful not to damage the rubber grommet.
NOTE: To prevent spilling windshield washer fluid, drain the windshield washer reservoir before washer pump removal.
Remove the rear window washer pump.
1
Disconnect the electrical connector.
2
Disconnect the hose.
3
Remove the rear window washer pump.
4. WARNING: Windshield washer solution contains methanol, which is poisonous. Observe all cautions and warnings indicated on the
label of the washer solution container. Failure to follow these instructions may result in personal injury.
CAUTION: Do not operate the windshield washer pump prior to filling the windshield washer reservoir. Failure to follow these
instructions may result in premature pump failure.
To install, reverse the removal procedure.
-
Fill the windshield washer reservoir with windshield washer fluid.