Depowering and Repowering of Supplemental Restraint System (SRS)
clip. Failure to do so may cause damage to the driver air bag module and or the steering wheel.
NOTE: The driver air bag module is removed for clarity.
Position the 3-mm Allen wrench or suitable tool against the wire clip and push inward disengaging the wire clip from the 3 driver air bag module
hooks.
9. Disconnect the horn electrical connector. Then disconnect the 2 driver air bag module electrical connectors and remove the driver air bag module.
10. Open and lower the glove compartment door.
11. Remove the 2 passenger air bag module bolts.
12. NOTICE: Do not handle the passenger air bag module by grabbing the edges of the deployment door. Failure to follow this instruction
may result in vehicle damage, equipment damage, component damage and/or system failure.
NOTE: Use care when removing the passenger air bag module from the instrument panel. The passenger air bag module can drop down during
removal and the passenger air bag module rear bracket can scratch the front of the instrument panel.
Through the glove compartment opening, release the passenger air bag module deployment door clips while pushing the passenger air bag module
out of the instrument panel.
13. Remove the passenger air bag module.
