Escape 2WD L4-2.5L (2009)
Clutch Slave Cylinder: Service and Repair
Clutch Slave Cylinder
Removal and Installation
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
For additional Information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result
in serious personal injury.
NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or
plastic surface, immediately wash the surface with water.
1. Remove the transaxle.
2. Disconnect the clutch slave cylinder-to-clutch hydraulic fluid tube adapter.
3. Remove the 3 clutch slave cylinder bolts and the clutch slave cylinder.
-
To install, tighten to 12 Nm (106 lb-in).
4. To install, reverse the removal procedure.
-
Bleed the air from the system.
