ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 6361 > < Initial Inspection and Diagnostic Overview|Page 6359
Page 1
background image

Garage Door Opener Transmitter: Pinpoint Tests

Universal Transmitter

Pinpoint Tests

Pinpoint Test A: The Universal Transmitter is Inoperative

Refer to Wiring Diagram Set 89 (Escape/Mariner, Escape Hybrid/Mariner Hybrid), Interior Lamps for schematic and connector information.  See:
Diagrams/Electrical Diagrams/Diagrams By Number

Normal Operation

The universal transmitter receives voltage through the battery saver relay power output circuit. The power and ground circuits are shared with the LH
vanity mirror lamp.

When a programmed button is pressed on the universal transmitter, a wireless signal is sent to the receiver unit. If the device does not operate the garage
door, it may be due to an incorrect programming procedure being carried out. Refer to Universal Transmitter Programming  See: Programming and
Relearning to verify the universal transmitter was correctly programmed. If necessary, contact the Lear Car2U(R) Customer Service Center at
866-572-2728, or the customer support website at www.learcar2u.com .

This pinpoint test is intended to diagnose the following:

-

Interior lighting concerns

-

Universal transmitter

-

Receiver unit

PINPOINT TEST A: THE UNIVERSAL TRANSMITTER IS INOPERATIVE

-------------------------------------------------
A1 CHECK THE LH SUN VISOR VANITY MIRROR OPERATION

-

Check the illumination of the LH sun visor vanity mirror lamps.

-

Do the vanity mirror lamps illuminate?

Yes

GO to A2.

No

REFER to Lighting and Horns to continue diagnosis of the vanity mirror lamps.

-------------------------------------------------
A2 PROGRAM A HAND-HELD TRANSMITTER INTO THE UNIVERSAL TRANSMITTER

-

Program the universal transmitter. Refer to Universal Transmitter Programming  See: Programming and Relearning.

-

Does the universal transmitter program successfully?

Yes

The universal transmitter is OK. VERIFY the receiver unit operates correctly by attempting to operate the device.

No

INSTALL a new LH sun visor assembly. TEST the system for normal operation.

-------------------------------------------------

Initial Inspection and Diagnostic Overview|Page 6361 > < Initial Inspection and Diagnostic Overview|Page 6359