Escape 2WD L4-2.5L Hybrid (2010)
Brake Master Cylinder: Testing and Inspection
Brake System Inspection
Brake Pads
Brake System Inspection
Brake Pads
NOTE: It is not required to install new brake pads when the brake discs are machined.
1. Inspect and measure the thickness of the brake pad friction material. For additional information, refer to Specifications.
-
Minor surface cracks do not require pad replacement, however, if there are missing chunks or cracks in the lining through to the backing plate,
install new brake pads. For additional information, refer to Disc Brake System for front brake pads.
-
If the thickness of the friction material is less than the specified thickness, install new brake pads. For additional information, refer to Disc
Brake System for front disc brakes.
-
If the friction material shows taper wear that is not within specifications, install new brake pads and verify the caliper guide pins are
functioning correctly. For additional information, refer to Brake Caliper Guide Pins inspection. See: Brake Caliper Guide Pins
Brake Shoes
Brake System Inspection
Brake Shoes
1. Inspect and measure the thickness of the brake shoe friction material. For additional information, refer to Specifications.
-
Minor surface cracks do not require shoe replacement, however, if there are missing chunks or cracks in the lining through to the backing plate,
install new brake shoes.
-
If the thickness of the friction material is less than the specified thickness, install new brake shoes.
-
Verify that the mounting hardware is installed correctly and operating correctly. Install new hardware as necessary.
-
Verify that the backing plate contact points are free of corrosion that may cause binding. Clean or install new as necessary.
-
Verify correct brake shoe adjustment.
-
For additional information, refer to Drum Brake System.
Brake Discs
Brake System Inspection
