Escape 2WD L4-2.5L Hybrid (2010)
2. NOTE: The booster push rod clevis-locking pin is a one-time use only part. Any time the booster push rod clevis-locking pin is removed, a new
booster push rod clevis-locking pin should be used.
NOTE: Remove the clevis-locking pin by squeezing the locking tabs and pulling outward on the opposite end.
Remove and discard the booster push rod clevis-locking pin.
3. Remove and discard the 4 brake booster nuts.
-
To install, tighten the new nuts to 23 Nm (17 lb-ft).
4. Disconnect the vacuum hose/check valve assembly from the brake booster.
Hybrid vehicles
5. Disconnect the vacuum sensor, booster solenoid and the booster travel sensor electrical connectors.
All vehicles
6. Remove and discard the 2 master cylinder nuts.
-
To install, tighten new nuts to 30 Nm (22 lb-ft).
7. NOTE: It is not necessary to disconnect the brake tube fittings.
Carefully position the brake master cylinder assembly forward and remove the brake booster.
8. NOTICE: Do not press, pull or otherwise move the brake pedal while installing the stoplamp switch. This switch must be installed with
the booster push rod attached to the brake pedal and with the brake pedal in the at-rest position. Installing this switch with the brake
pedal in any other position will result in incorrect adjustment and may damage the switch.
To install, reverse the removal procedure.
Hybrid vehicles
9. Following the scan tool instructions, carry out the Multi-Calibration Routine.