Escape 2WD L4-2.5L Hybrid (2010)
11. NOTICE: Only hand-tighten the bolt or damage to the front cover can occur.
Using the 6 mm x 18 mm bolt, check the position of the crankshaft pulley.
-
If it is not possible to install the bolt, the engine valve timing must be corrected by repeating this procedure.
12. Install the Camshaft Alignment Plate to check the position of the camshafts.
-
If it is not possible to install the Camshaft Alignment Plate, the engine valve timing must be corrected by repeating this procedure.
13. Remove the Camshaft Alignment Plate.
14. Remove the 6 mm x 18 mm bolt.
