Escape 2WD L4-2.5L Hybrid (2010)
Heater Core: Service and Repair
Heater Core
Removal and Installation
NOTE: If a heater core leak is suspected, the heater core must be leak tested before the heater core is removed.
NOTE: Use only the approved coolant for this vehicle. For additional information, refer to Cooling System &/or Engine Block Heater.
1. Remove the heater core and evaporator core housing. For additional information, refer to Heater Core And Evaporator Core Housing See:
Housing Assembly HVAC/Service and Repair/Removal and Replacement.
2. Remove the dash panel seal.
3. Remove the heater core bracket screw and the heater core bracket.
-
To install, tighten to 3 Nm (27 lb-in).
4. Remove the heater core.
5. To install, reverse the removal procedure.
