Escape 2WD L4-2.5L Hybrid (2010)
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm (133 lb-in).
5. Remove the receiver/drier outlet fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm (133 lb-in).
6. Remove the 2 receiver/drier nuts.
-
To install, tighten to 7 Nm (62 lb-in).
7. NOTICE: Motorcraft(R) Electric Compressor Oil only must be used as a refrigerant system lubricant for hybrid vehicles. Addition of
any oil other than Motorcraft(R) Electric Compressor Oil to the hybrid vehicle refrigerant system will damage the electric Air
Conditioning (A/C) compressor and contaminate the refrigerant system.
To install, reverse the removal procedure.
-
Install new gasket seals and O-ring seals.
-
Add the correct amount of clean electric A/C compressor oil to the refrigerant system.
8. Evacuate, leak test and charge the refrigerant system.
