Escape 2WD L4-2.5L Hybrid (2010)
2. Pull out and separate the quarter trim panel at the D-pillar trim panel.
3. Pull out to release the retainers and remove the D-pillar trim panel.
11. Disconnect the driver side Safety Canopy(R) module electrical connector.
12. From under the rear of the driver seat, slide and disengage the driver seat side air bag module electrical connector locking clip, and then release
the tab and disconnect the driver seat side air bag module electrical connector.
13. Install RCM fuse 31 (10A) to the SJB.
14. Connect the battery ground cable. For additional information, refer to Battery.
Reactivation
1. Remove RCM fuse 31 (10A) from the SJB.
2. Disconnect the battery ground cable and wait at least one minute. For additional information, refer to Battery.
3. Connect the driver seat side air bag module electrical connector and then slide and engage the seat side air bag electrical connector locking clip.
4. Connect the driver side Safety Canopy(R) module electrical connector.
