Escape 2WD L4-2.5L Hybrid (2010)
Oil Pressure Sender: Service and Repair
Engine Oil Pressure (EOP) Switch
Engine Oil Pressure (EOP) Switch
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Remove the pin-type retainer, the 5 bolts and the RH splash shield.
-
To install, tighten to 9 Nm (80 lb-in).
3. Disconnect the Engine Oil Pressure (EOP) switch electrical connector.
4. Remove the EOP switch.
-
To install, tighten to 15 Nm (133 lb-in).
5. To install, reverse the removal procedure.
-
Apply thread sealant with PTFE to the EOP switch threads.
