ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2566 > < Initial Inspection and Diagnostic Overview|Page 2564
Page 51
background image

GO to S9. 

No

GO to S10.

-------------------------------------------------
S9 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE 4X4 CONTROL MODULE DISCONNECTED

NOTE:  When re-running the network test, the network test application must be first closed or the screen display reverts back to the prior run network
test results.

-

Disconnect: 4X4 Control Module C3184 .

-

Enter the following diagnostic mode on the scan tool: Network Test .

-

Repeat the network test.

-

Do all other modules pass the network test?

Yes

CONNECT the 4X4 control module. GO to Pinpoint Test D.  See: Pinpoint Test D: The 4X4 Control Module Does Not Respond To The Scan Tool 

No

CONNECT the 4X4 control module. GO to S10.

-------------------------------------------------
S10 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE PAM DISCONNECTED

NOTE:  When re-running the network test, the network test application must be first closed or the screen display reverts back to the prior run network
test results.

-

Disconnect: PAM C4014 .

-

Enter the following diagnostic mode on the scan tool: Network Test .

-

Repeat the network test.

-

Do all other modules pass the network test?

Yes

CONNECT the PAM. GO to Pinpoint Test J.  See: Pinpoint Test J: The Parking Aid Module (PAM) Does Not Respond To The Scan Tool 

No

CONNECT the PAM. GO to S11.

-------------------------------------------------
S11 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE RCM DISABLED

NOTE:  When re-running the network test, the network test application must be first closed or the screen display reverts back to the prior run network
test results.

-

Disconnect: SJB Fuse 31 (10A) .

-

Enter the following diagnostic mode on the scan tool: Network Test .

-

Repeat the network test.

-

Do all other modules pass the network test?

Yes

INSTALL the removed fuse. GO to Pinpoint Test E.  See: Pinpoint Test E: The Restraints Control Module (RCM) Does Not Respond To The Scan Tool

No

INSTALL the removed fuse. GO to S12.

-------------------------------------------------
S12 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE OCSM DISABLED

Initial Inspection and Diagnostic Overview|Page 2566 > < Initial Inspection and Diagnostic Overview|Page 2564