Escape 2WD L4-2.5L Hybrid (2010)
-
Is the voltage greater than 6 volts?
Yes
REPAIR the circuit. CLEAR the DTCs. REPEAT the network test with the scan tool.
No
The Controller Area Network (CAN) has tested within specifications. GO to Pinpoint Test U to diagnose the intermittent MS-CAN fault. See: Pinpoint
Test U: Intermittent No Medium Speed Controller Area Network (MS-CAN) Communication, Communication Can Be Intermittent
-------------------------------------------------
V5 CHECK THE MS-CAN TERMINATION RESISTOR
-
Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.
-
Is the resistance between 108 and 132 ohms?
Yes
GO to V6.
No
GO to V9.
-------------------------------------------------
V6 CHECK THE MS-CAN TERMINATION RESISTOR WITH THE SJB DISCONNECTED
-
Disconnect: Smart Junction Box (SJB) C2280b .
-
Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.
-
Is the resistance between 108 and 132 ohms?
Yes
GO to V7.
No
GO to V8.
-------------------------------------------------
V7 CHECK THE MS-CAN CIRCUITS BETWEEN THE SJB AND THE DLC FOR AN OPEN
-
Measure the resistance between the SJB C2280b-37, circuit VDB06 (GY/OG), harness side and the DLC C251-3, circuit VDB06 (GY/OG),
