ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Emissions - Rough Running/Hard Start/DTC's Set|Page 2900 > < Emissions - Rough Running/Hard Start/DTC's Set|Page 2894
Page 1
background image

Canister Purge Control Valve: All Technical Service Bulletins
Emissions - Rough Running/Hard Start/DTC's Set

TSB 11-1-5

01/25/11

RUNS ROUGH, HARD START AFTER REFUELING,
AUDIBLE CLICKING NOISE UNDER HOOD, AND/OR
DTCS P0316, P144A, P1450, PO17X, P044X, P045X,
BUILT ON OR BEFORE 11/1/2010

FORD:
2010-2011 Fusion
2009-2010 F-150
2009-2011 E-Series, Escape, Expedition
2011 F-250, F-350

LINCOLN:
2011 MKZ
2009-2011 Navigator

MERCURY:
2010-2011 Milan
2009-2011 Mariner

ISSUE
Some 2009-2010 F-150, 2009-2011 Expedition, Navigator, E-Series, Escape Hybrid, Mariner Hybrid, 2010-2011 Fusion Hybrid, Milan Hybrid, 2011
MKZ Hybrid and F-Super Duty 250/350 equipped with a 6.2L engine and built on or before 11/1/2010, may exhibit a running rough concern, hard start
after refueling, audible clicking noise under the hood and/or diagnostic trouble codes (DTCs) P0316, P144A, P1450, PO17X, P044X, P045X.

ACTION
Follow the Service Procedure to correct the condition.

SERVICE PROCEDURE

Replace the Evaporative Emission Canister Purge Valve. Refer to Workshop Manual, Section 303-13.

Parts Block

WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage And Emissions Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.

Emissions - Rough Running/Hard Start/DTC's Set|Page 2900 > < Emissions - Rough Running/Hard Start/DTC's Set|Page 2894