Escape 2WD L4-2.5L Hybrid (2010)
1. Install the side air bag module and nuts onto the seat backrest frame mounting bracket.
-
Tighten to 5 Nm (44 lb-in).
2. Attach the 2 side air bag module wiring harness retainers to the seat backrest frame.
3. Roll down the seat trim cover to the side air bag module.
4. WARNING: Check the seat side air bag deployment chute for damage. The deployment chute must not be repaired. If there is any
damage to the deployment chute, a new seat back trim cover and deployment chute must be installed as a unit. Failure to follow these
instructions may result in the seat side air bag module deploying incorrectly and increase the risk of serious personal injury or death in a
crash.
Feed the side air bag module deployment chute and J-clips back through the side air bag module seat backrest foam opening.
5. WARNING: If the seat side air bag module deployment chute is not correctly positioned and closed, the seat side air bag module may not
deploy correctly. Failure to follow these instructions may result in the seat side air bag module deploying incorrectly and increases the
risk of serious personal injury or death in a crash.
Install the side air bag module deployment chute and J-clips around the side air bag module and seat backrest frame.
6. Roll the seat backrest trim cover down in position and attach the hook-and-loop strips.
7. Feed the seat backrest trim cover rear J-clip through seat between the seat backrest and seat cushion.
8. Attach the seat backrest trim cover J-clips.
