Escape 2WD L4-2.5L Hybrid (2010)
from the seat cushion foam pad.
Detach the seat cushion trim cover J-clips from the seat cushion pan and remove the seat cushion trim cover.
6. Remove the seat cushion foam pad.
7. Bend the retaining tab away from the pressure sensor, then slide the pressure sensor off the bracket.
8. NOTICE: Care must be taken to prevent damage to the seat cushion pan when removing the rivets.
Remove the 2 rivets and the OCSM.
9. Remove the 2 pin-type retainers from the OCS bladder and seat cushion pan.
10. Feed the OCS hose and pressure sensor through the seat cushion pan opening and remove as an assembly with the bladder.
Installation
NOTICE: To prevent system failure, it is necessary to carry out the Occupant Classification Sensor (OCS) system reset when a front passenger
seat cushion is disassembled, a new trim cover installed or an OCS system service kit is installed. A scan tool is used to carry out the OCS
system reset command.
NOTICE: Do not install a new cushion heater mat on a front passenger seat cushion, it is not serviceable separately. If a new cushion heater
mat is needed on the front passenger seat, an Occupant Classification Sensor (OCS) system service kit equipped with a heater mat must be
installed. Failure to follow this instruction may result in incorrect operation of the OCS system.
1. Bend the retaining tab back on the pressure sensor component bracket.
2. NOTICE: Inspect the Occupant Classification Sensor (OCS) bladder, seat cushion pan and support assembly for any foreign objects
before installing the OCS to the seat cushion pan. If any foreign objects are found, remove them. Failure to follow these instructions may
result in incorrect operation of the OCS system and may cause system failure.
NOTICE: Route the seat Occupant Classification Sensor (OCS) components through the correct seat cushion support opening. Failure to
follow these instructions may result in component damage and/or system failure.
NOTICE: While positioning the seat cushion pan and Occupant Classification Sensor (OCS) assembly, be careful not to damage any of
the components.
Feed the OCS components (pressure sensor and hose) through the seat cushion pan opening.
