Escape 2WD L4-2.5L Hybrid (2010)
Child Seat Tether Attachment: Service and Repair
Child Safety Seat Tether Anchor
Removal and Installation
WARNING: After any crash, all of the following safety belt assemblies and attaching hardware must be inspected by an authorized dealer to
verify correct function:
-
Retractors
-
Buckles
-
Belt tension sensor (BTS) (if equipped)
-
Front safety belt buckle support assemblies (slide bar) (if equipped)
-
Safety belt shoulder belt height adjusters (if equipped)
-
Child safety seat tether bracket assemblies
-
Automatic locking retractor (ALR) feature for child safety seats (passenger seating positions only)
If any safety belt assembly is damaged, does not operate correctly or does not pass all of the Functional Tests in the Diagnosis and Testing, a
new safety belt assembly must be installed. If any safety belt assembly attaching areas are damaged or distorted, the sheet metal must be
restored to its original structural integrity and new safety belt assembly and attaching hardware must be installed. Failure to install new safety
belt assemblies and attaching hardware may increase the risk of serious personal injury or death in a crash.
After any crash that results in deployment of the driver and/or front outboard passenger safety belt pretensioners, new driver and/or front
outboard passenger safety belt systems (including retractors, buckles and height adjusters) must be installed. Failure to install new safety belt
systems increases the risk of serious personal injury or death in a crash.
1. Remove the child safety seat tether anchor cover by releasing the top anchor end of the cover first and rocking the cover off of the anchor bolt end.
2. Remove the bolt and child safety seat tether anchor.
-
To install, tighten to 22 Nm (16 lb-ft).
3. WARNING: Always tighten the child safety seat tether anchor/bolt to specification. Failure to follow this instruction may result in the
child's safety seat being incorrectly secured, which increases the risk of serious personal injury or death to the child in a sudden stop or
crash.
To install, reverse the removal procedure.
