Escape 2WD L4-2.5L Hybrid (2010)
4. Remove the nut, bolts and engine support crossmember. Discard the nut. (Figure 3)
5. Replace the engine support crossmember with improved service level crossmember. Tighten the bolts to 66 lb-ft. (90 N.m), tighten the new nut to
129 lb-ft. (175 N.m). (Figure 3)
NOTE
THIS PART IS ONLY APPLICABLE TO 2009-2010 VEHICLES BUILT BEFORE 8/10/2009, AND WILL NOT CORRECT ANY OTHER
SYMPTOM.
6. Install the rear roll restrictor-to-crossmember through bolt. Tighten to 66 lb-ft. (90 N.m). (Figure 2)
7. Install the lower transaxle insulator through bolt. Tighten to 85 lb-ft. (115 N.m). (Figure 1)
8. Enable the vehicle high voltage electrical system following WSM, Section 414-03.
Parts Block
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
OPERATION
DESCRIPTION
TIME
092219A
2009-2010 Escape Hybrid,
0.6 Hr.
Mariner Hybrid: Replace
The Engine Support Cross
Member (Do Not Use With
Any Other Labor
Operations)
DEALER CODING
CONDITION
BASIC PART NO.
CODE
6P094
07
Disclaimer
