Escape 2WD L4-2.5L Hybrid (2010)
10. Disconnect the Output Shaft Speed (OSS) sensor electrical connector.
11. Remove the main control cover grommet.
12. NOTICE: Be careful not to bend or twist the leadframe or the solenoid terminals when removing the leadframe or damage can occur to
the leadframe or the solenoids.
Remove the 5 screws and the leadframe from the solenoids by lifting it straight up evenly.
13. Using a paint pen, number the solenoids and solenoid body to clearly mark which solenoid was removed from which bore in the solenoid body.
