Escape 2WD L4-2.5L Hybrid (2010)
4. Remove the bolts and the lateral support crossmember.
-
To install, tighten to 115 Nm (85 lb-ft).
5. Remove the lower insulator through bolt.
-
To install, tighten to 115 Nm (85 lb-ft).
6. Remove the rear roll restrictor-to-crossmember through bolt.
-
To install, tighten to 90 Nm (66 lb-ft).
7. Remove and discard the engine support crossmember nut. Remove the 2 engine support crossmember bolts.
-
To install, tighten the new engine support crossmember nut to 175 Nm (129 lb-ft).
-
To install, tighten the 2 engine support crossmember bolts to 90 Nm (66 lb-ft).
8. Remove the engine support crossmember.