Escape 2WD L4-2.5L Hybrid (2010)
10. WARNING: Do not drive vehicle until the urethane adhesive seal has cured. Follow urethane adhesive manufacturer's curing directions.
Inadequate or incorrect curing of the urethane adhesive seal will adversely affect glass retention. Failure to follow these instructions may
result in serious injury to vehicle occupant(s).
NOTICE: Before positioning the windshield glass, open vehicle windows to prevent the air pressure of closing doors from affecting the
urethane adhesive bond.
Install the windshield glass, aligning it to the marks previously made.
11. NOTE: The urethane adhesive must cure for a minimum of one hour before testing for air and water leaks.
After the urethane adhesive has cured, check for water leaks and add urethane adhesive where needed.
12. If necessary, remove excess urethane adhesive from the exterior surface of the windshield glass.
13. Install the cowl panel grille.
14. Reposition the front portion of the headliner.
15. Install the LH and RH sun visors and visor clips.
-
If equipped, connect the electrical connectors.
16. Install the interior rear view mirror. For additional information, refer to Mirrors.
17. Position the overhead console and install the 2 overhead console screws.
-
If equipped, connect the electrical connector.
18. Install the 2 windshield side garnish mouldings.
19. Install the LH and RH A-pillar trim panels.
