Escape 2WD V6-182 3.0L VIN 1 SFI (2002)
The use of rental vehicles is not authorized for this program.
CLAIMS PREPARATION AND SUBMISSION
^
Enter claims using Direct Warranty Entry (DWE).
^
Refund must be claimed on a repair line that is separate from the repair line on which the FSA is claimed.
^
Refer to ACESII manual for claims preparation and submission information.
Attachment II - Labor Allowances and Parts Ordering Information
LABOR ALLOWANCES
PARTS REQUIREMENTS/ORDERING INFORMATION
NOTE:
PCM replacement will not be covered under this program.
DEALER PRICE
Not applicable.
PARTS RETENTION AND RETURN
Not applicable.
EXCESS STOCK RETURN
Not applicable.
Attachment III - Technical Information
SERVICE PROCEDURE
1.
Reprogram the PCM to the latest level calibration. Use one (1) of the following two (2) methods:
^
Worldwide Diagnostic System (WDS), updated to release level B30.7 or later.
^
New Generation STAR (NGS) Tester with Rotunda Flash Cable (007-00531) and Rotunda Flash Card (007-00532). The calibration must be
downloaded to a flash card using WDS updated to release level B30.7 or later.
NOTE:
If the PCM is already programmed to the latest level calibration, reprogramming is not necessary.
IF UNABLE TO REPROGRAM PCM
^
PCM replacement will not be covered under this program.
^
Prior to disconnecting the WDS from the vehicle and closing the session, call the Special Service Support Center at 1-800-325-5621.
