Escape 2WD V6-182 3.0L VIN 1 SFI (2002)
10. Install the C-pillar weatherstripping.
11. Install the rear door scuff plate.
1
Position the rear door scuff plate.
2
Install the two pin-type retainers (one shown).
3
Close the cover.
12. Check the active restraint system for correct operation.
1
Make sure that after the rear safety belt retractor is installed, the retractor is not in the Automatic Locking Retractor (ALR) mode.
2
Carry out the Emergency Locking Retractor (ELR) Mode Functional Test to make sure that the new retractor operates correctly. See: Testing
and Inspection/Component Tests and General Diagnostics/Functional Test - Emergency Locking Retractor (ELR) Mode
Front Safety Belt Retractor
Safety Belt Bolt Bit
SPECIAL TOOL(S)
REMOVAL
WARNING: ALL SAFETY BELT ASSEMBLIES INCLUDING RETRACTORS, BUCKLES, FRONT SEAT BELT BUCKLE SUPPORT
ASSEMBLIES (SLIDE BAR), SHOULDER BELT HEIGHT ADJUSTERS (IF SO EQUIPPED), CHILD SAFETY SEAT TETHER
ATTACHMENTS, AND ATTACHING HARDWARE SHOULD BE INSPECTED AFTER ANY COLLISION. ALL BELT ASSEMBLIES
SHOULD BE REPLACED UNLESS A QUALIFIED TECHNICIAN FINDS THE ASSEMBLIES SHOW NO DAMAGE AND OPERATE
PROPERLY. BELT ASSEMBLIES NOT IN USE DURING A COLLISION SHOULD ALSO BE INSPECTED AND REPLACED IF EITHER
DAMAGE OR IMPROPER OPERATION IS NOTED.
NOTE: The driver side is shown, the passenger side is similar.
1. Remove the B-pillar trim panel.
