Escape 2WD V6-182 3.0L VIN 1 SFI (2002)
6. Inspect the O-ring seal for nicks or cuts. Install a new seal as necessary.
Installation
1. NOTE: Apply a light coat of petroleum jelly to the O-ring seal before installation.
Install the TSS sensor.
^
Connect the TSS electrical connector (white connector).
2. Remove the drain pan.
3. Install the splash shield.
4. Install the LH front wheel.
5. Lower the vehicle.
6. Check the transmission fluid level, add fluid as necessary using clean automatic transmission fluid.
7. Start the engine and move the transaxle range selector lever through all gear positions.
