Escape 2WD V6-3.0L (2009)
2. Remove the safety belt buckle pretensioner.
-
Disconnect and detach the safety belt buckle pretensioner and buckle switch electrical connectors from the seat track.
-
Detach the wiring harness pin-type retainer.
-
Route the wiring harness from between the seat track and cushion frame.
3. Disconnect the electrical connector(s).
-
Disconnect the seat position sensor electrical connector and detach the wiring harness.
-
If equipped, disconnect the power seat track electrical connector and detach the wiring harness.
-
Detach the seat harness electrical connector from the seat track.
4. Remove the 4 bolts and seat track.
-
To install, tighten to 25 Nm (18 lb-ft).
5. If equipped, disconnect the cushion heater mat electrical connector.
6. NOTICE: Use care when separating the seat cushion trim cover from the hook-and-loop strips or the hook-and-loop strips may be torn
from the seat cushion foam pad.
Release the all the retainers and remove the cushion cover.
7. Remove the cushion foam pad.
-
If equipped, note heater mat wire harness routing for correct installation.
8. If equipped, release the locking tab and remove the heated seat relay from the bracket on the cushion frame.
-
Disconnect the relay electrical connector.
9. To assemble, reverse the disassembly procedure.
Seat Cushion - Front, Passenger Side
Seat Cushion - Front, Passenger Side
NOTE: Seat equipped with a production Occupant Classification Sensor (OCS) system shown. For OCS system service components, refer to Occupant
Classification Sensor - Service Kit procedure in Air Bag Systems.
