Escape 2WD V6-3.0L (2009)
Brake Caliper: Testing and Inspection
Brake Caliper Guide Pins
Brake System Inspection
Brake Caliper Guide Pins
1. The guide pins should slide with a reasonable amount of hand force. If the brake pads show taper wear or the guide pins are difficult to move,
carry out the following steps.
-
Disassemble the brake caliper guide pins and inspect the guide pins and guide pin bores for wear, damage and corrosion. If bore is worn or
damaged, replace the damaged component.
-
Use a wire brush, rolled-up sandpaper or emery cloth to remove all corrosion and foreign material from the caliper guide pin bores. Clean any
remaining foreign material from the bores with brake parts cleaner and compressed air.
-
Assemble the caliper guide pins using new caliper seals, boots and guide pins. Use an ample amount of the specified grease to lubricate the
bores and guide pins.
-
Inspect the brake pads. For additional information, refer to Brake System Inspection. See: Testing and Inspection/Component Tests and
General Diagnostics/Brake System Inspection
