Escape 2WD V6-3.0L (2009)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Hydraulic Control Unit (HCU)
Removal and Installation
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of
serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result
in serious personal injury.
NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or
plastic surface, immediately wash the surface with water.
NOTE: When installing a new ABS module/Hydraulic Control Unit (HCU) assembly, it must be configured (either by download/upload or uploading
the as-built data method).
All vehicles
1. Remove the Air Cleaner (ACL) and the ACL outlet pipe.
2. Disconnect the master cylinder brake tube fittings from the HCU.
-
To install, tighten to 23 Nm (17 lb-ft).
Vehicles with 3.0L engine
3. Disconnect the master cylinder brake tube fittings from the master cylinder and remove the brake tubes.
-
To install, tighten to 23 Nm (17 lb-ft).
All vehicles
4. NOTE: The brake tubes must be installed in the same location as removed.
