Escape 2WD V6-3.0L (2009)
Parking Brake Cable: Removal and Replacement
Parking Brake Cable - Rear, LH
Parking Brake Cable - Rear, LH
NOTE: Rear disc shown, rear drum similar.
Removal and Installation
1. Release the parking brake cable tension. For additional information, refer to Parking Brake Cable Tension Release See: Procedures.
2. Remove the rear brake shoes.
3. Disconnect the parking brake cable from the cable connector and the equalizer bracket by compressing the cable conduit locking tabs.
4. Detach the cable-to-fuel tank strap pin type retainer.
5. Remove the 2 parking brake cable bracket bolts.
-
To install, tighten to 23 Nm (17 lb-ft).
6. Compress the rear parking brake cable conduit locking tabs and pull the cable assembly through the brake backing plate.