Escape 2WD V6-3.0L (2009)
2. Position the valve cover and install the 11 bolts and 3 stud bolts.
-
Tighten in the sequence shown to 10 Nm (89 lb-in).
3. Attach the CKP wiring harness retainer on the stud.
4. Connect the VCT electrical connector.
5. Attach the 3 main engine control wiring harness retainers to the valve cover.
6. Attach the 3 main engine control wiring harness retainers to the valve cover stud bolts.
7. Install the RH ignition coil-on-plugs.
