Escape 2WD V6-3.0L (2009)
9. Connect the CKP electrical connector.
10. Attach the wiring harness retainer to the engine front cover stud bolt.
11. Install the accessory drive belt tensioner and the 3 bolts.
-
Tighten to 25 Nm (18 lb-ft).
12. Position the generator and install the stud.
-
Tighten to 8 Nm (71 lb-in).
13. Install the generator bolt and 2 nuts.
-
Tighten to 47 Nm (35 lb-ft).
14. Install the crankshaft front seal. For additional information, refer to Lower End Components - Exploded View See: Service and Repair/Removal
and Replacement/Lower End Components - Exploded View and Crankshaft Front Seal See: Seals and Gaskets/Front Crankshaft Seal/Service and
Repair/Crankshaft Front Seal.
15. Fill the engine with clean engine oil.
16. Connect the battery ground cable.
17. Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.
