Escape 2WD V6-3.0L (2009)
10. NOTICE: Do not handle the passenger air bag module by grabbing the edges of the deployment door. Failure to follow this instruction
may result in vehicle damage, equipment damage, component damage and/or system failure.
NOTE: During passenger air bag module installation, make sure all the deployment door clips are fully seated into the instrument panel.
NOTE: Use care when installing the passenger air bag module in the instrument panel. The passenger air bag module rear bracket can scratch the
front of the instrument panel.
Position the passenger air bag module and seat the passenger air bag module deployment door clips into the instrument panel.
11. Install the 2 passenger air bag module bolts.
-
To install, tighten to 8 Nm (71 lb-in).
12. Close the glove compartment door.
13. Install the driver air bag module electrical connectors fully into the driver air bag module. Then connect the horn electrical connector.
14. NOTE: Make sure the driver air bag module wiring harness is routed down and away from the driver air bag module hooks during installation.
NOTE: Audible clicks will be heard when the 3 wire clips are seated in the 3 driver air bag module hooks.
Align the driver air bag module hooks to the steering wheel and, while pushing inward, seat the 3 driver air bag module hooks to the steering
wheel wire clip.
-
When the 3 driver air bag module hooks are seated in place, gently pull outward at the corners of the driver air bag module to make sure that
the 3 hooks are fully seated. There should also be an even gap between the driver air bag module trim cover and the steering wheel. Check the
driver air bag module and trim cover for correct movement when applying the horn.
15. Turn the ignition switch from OFF to ON.
16. Install RCM fuse 32 (10A) to the SJB and install the cover.
