Escape 2WD V6-3.0L (2009)
-
Is the voltage greater than 10 volts?
Yes
The vehicle is operating correctly. SEND the trailer to an authorized camper/trailer repair facility.
No
GO to AA2.
-------------------------------------------------
AA2 CHECK THE TRAILER TOW PARKING LAMP RELAY
-
Place the headlamp switch in the OFF position.
-
Disconnect: Trailer Tow Parking Lamp Relay.
-
Substitute a known good relay.
-
Measure the voltage between the trailer tow C439-3, circuit CAT11 (BN), harness side and ground.
-
Is the voltage greater than 10 volts?
Yes
REMOVE the known good relay. INSTALL a new trailer tow parking lamp relay. TEST the system for normal operation.
No
REMOVE the known good relay. GO to AA3.
-------------------------------------------------
AA3 CHECK CIRCUIT CLS30 (VT/WH) FOR AN OPEN
-
Place the headlamp switch in the PARKING LAMPS ON position.
-
Measure the voltage between the trailer tow parking lamp relay pin 2, circuit CLS30 (VT/WH), BJB face side and ground.
-
Is the voltage greater than 10 volts?
Yes
GO to AA4.
No
REPAIR circuit CLS30 (VT/WH) for an open. TEST the system for normal operation.
