Escape 2WD V6-3.0L (2009)
-
To install, tighten to 8 Nm (71 lb-in).
5. Remove the condenser outlet fitting nut and disconnect the fitting.
-
Discard the O-ring seal.
6. Remove the evaporator outlet line fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm (133 lb-in).
7. Remove the auxiliary evaporator outlet line fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seals.
-
To install, tighten to 15 Nm (133 lb-in).
8. Remove the receiver/drier inlet fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm (133 lb-in).
9. Remove the condenser-to-receiver/drier line.
10. To install, reverse the removal procedure.
-
Install new gasket seal and O-ring seal.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
11. Evacuate, leak test and charge the refrigerant system.
