Escape 2WD V6-3.0L (2009)
6. NOTE: This step may not be necessary if the inner wheel bearing race remains in the wheel knuckle after removing the wheel hub.
Using a suitable press and the Pinion Bearing Cone Remover or equivalent, press the inner bearing race from the wheel knuckle.
7. Remove and discard the wheel bearing snap ring.
8. Using the Impact Slide Hammer or equivalent and the Axle Bearing Remover, remove the bearing from the wheel knuckle.
Installation
1. Using the Rear Axle Drawbar, Bearing Cup Replacer and Differential Bearing Cup Replacer, install a new wheel bearing into the wheel knuckle.
2. Install the new wheel bearing snap ring.
3. Using the Half Shaft Installer and Receiver Adapter, install the wheel hub into the wheel bearing.
4. Install the wheel speed sensor ring.
5. Install the brake drum.
6. NOTE: Apply the brake to keep the halfshaft from rotating.
Install the new wheel hub nut.
