Escape 2WD V6-3.0L (2009)
WARNING: Wear high-voltage insulated safety gloves and a face shield when working with high-voltage batteries or cables. The high-voltage
insulated safety gloves should be of the appropriate safety and protection rating. Inspect the gloves before use and always wear them with the
leather outer glove. Any hole in the rubber insulating glove is a potential entry point for high-voltage. Failure to follow these instructions may
result in serious personal injury or death.
WARNING: Turn OFF the ignition switch for a minimum of 5 minutes before removing high-voltage cables. High-voltage cables and wiring
are orange in color. The nominal high-voltage traction battery voltage (HVTB) is 330 V DC. Failure to follow these instructions may result in
serious personal injury or death.
1. Verify the customer concern.
2. Visually inspect for obvious signs of electrical damage.
Visual Inspection Chart
3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
4. If the cause is not visually evident, verify the symptom and GO to Symptom Chart. See: Symptom Related Diagnostic Procedures
5. Clear the continuous DTCs and carry out the Self Test Diagnostics for the PCM.
6. If the DTCs retrieved are related to this concern, go to the DTC Chart. For all other DTCs, refer to Body Control Systems. See: Diagnostic
Trouble Code Descriptions
