Escape 2WD V6-3.0L (2009)
Engine Control Module: Removal and Replacement
Powertrain Control Module (PCM)
Removal
1. NOTE: PCM installation DOES NOT require new keys or programming of keys, only a Parameter Reset of the Passive Anti-Theft System
(PATS).
Retrieve the module configuration. Carry out the module configuration retrieval steps of the Programmable Module Installation (PMI) procedure.
See: Information Bus/Testing and Inspection/Programming and Relearning
2. Detach the wiring harness retainer from the cowl stud bolt.
3. Disconnect the 3 PCM electrical connectors.
4. Remove the 2 bolts and the PCM.
5. Remove and inspect the PCM cowl seal; install new if damaged.
Installation
1. Install the PCM cowl seal.
2. Install the PCM and the 2 bolts.
-
Tighten to 8 Nm (71 lb-in).
3. Connect the 3 PCM electrical connectors.
