Escape 2WD V6-3.0L (2009)
3. Disconnect the battery ground cable.
Hybrid vehicles
4. Remove the front and rear auxiliary evaporator outlet and inlet lines.
All vehicles
5. NOTE: Some residual fuel may remain in the fuel tubes after releasing the fuel system pressure. Upon disconnecting or removing any fuel tubes,
carefully drain any residual fuel into a suitable container.
Disconnect the fuel supply jumper tube-to-fuel supply tube quick connect coupling.
6. Disconnect the fuel vapor tube-to-vapor tube quick connect coupling.
7. Remove the Fuel Pump (FP) module access cover.
8. NOTE: Place absorbent toweling in the immediate surrounding area in case of fuel spillage.
Disconnect the fuel tube-to-FP module quick connect coupling.
9. Disconnect the Evaporative Emission (EVAP) canister purge tube-to-vapor tube quick connect coupling (part of 9E857).
10. Release the 7 fuel tube bundle retainer clips and remove the fuel supply and vapor tubes.
11. Disconnect the fresh air tube from the EVAP canister.
12. Release the 4 pin-type retainer clips and remove the fresh air tube.
13. To install, reverse the removal procedure.
