Escape 2WD V6-3.0L (2009)
PART AND TOOL REQUIREMENTS
NOTE:
Special tools that are needed for this portion of the service procedure are as follows:
^
Transaxle Holding Fixture # 307-625 or equivalent
^
Torque Converter Retainer # 307-566
^
Torque Converter Handle # 307-091
^
Overdrive Clutch, Balance Piston and Direct Drive Clutch Compressor # 307-589/1
^
Forward/Intermediate Spring Compressor # 307-584/2
^
Dial Indicator Gauge with Holding Fixture # 100-002 or equivalent
^
Shim Selection Gauge # 307-300
^
Turbine Shaft Seal Protector # 307-635
^
Suitable Depth Gauge
Transaxle Removal
1. Remove the transaxle from the vehicle For additional information refer to the appropriate WSM Section 307.
Transaxle Disassembly
If the technician determines that the transmission is contaminated and damaged to the point that a complete overhaul is necessary, dealers must perform a
cost cap analysis using the cost cap tool found on the Professional Technician Society (PTS) website.
If the cost cap tool states "Repair", contact the Special Service Support Center (SSSC) with the repair estimate (parts and labor at warranty prices) Be
prepared to provide the dealership's P/A code and have the repair order, which contains the VIN and mileage of the vehicle.
If the cost cap tool states "Replace" continue with the Transmission Prior Approval request, make sure to select FSA on the main menu.
1. Install the Transaxle Holding Fixture # 307-625 onto the transaxle.
2. Using the Transaxle Holding Fixture # 307-625 install the transaxle on a bench-mounted holding fixture.
3. Remove the Torque Converter Retainer # 307-566.
4. Install the Torque Converter Handle # 307-091.
5. NOTICE: The torque converter is heavy. Be careful not to drop it or damage will result.
Using Torque Converter Handle #307-091,remove the torque converter from the transaxle.
6. NOTE: Record the location of the stud bolts for assembly.
