Service and Repair for Air Bag Trim Cover - Passenger | Escape 2WD V6-30L (2009)
4. Disconnect the horn and 2 driver air bag module electrical connectors and remove the driver air bag module.
Installation
1. Connect the driver air bag module and horn electrical connectors.
2. NOTE: Make sure the wiring harness is routed away from the driver air bag module hooks during installation.
Align the driver air bag module hooks to the steering wheel and seat the 3 driver air bag module hooks.
-
When the 3 driver air bag module hooks are seated, gently pull outward at the corners of the driver air bag module to make sure all 3 hooks are
fully seated. Check the driver air bag module and trim cover for correct movement when applying the horn.
3. Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering See: Air Bag(s)
Arming and Disarming/Service and Repair/Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures.
