Escape 2WD V6-3.0L (2009)
10. Connect the safety canopy module electrical connector and attach the connector to the D-pillar.
11. Install the safety canopy module wiring clip to the roof panel brace.
12. Install the remaining 2 rear safety canopy module bolts near the ignitor (between the C- and D-pillars).
-
Tighten to 8 Nm (71 lb-in).
13. Install the headliner.
14. Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering See: Air Bag(s)
Arming and Disarming/Service and Repair/Supplemental Restraint System (SRS) Depowering and Repowering.
