Escape 2WD V6-3.0L (2009)
Feed the OCS components (pressure sensor and hose) through the seat cushion pan opening.
3. Align the OCS bladder to the seat cushion pan.
4. Install the 2 pin-type retainers to the OCS bladder and seat cushion pan.
5. NOTE: Make sure the pressure sensor hose is not kinked during installation.
Install the pressure sensor onto the seat cushion pan bracket, making sure the retaining tab is completely engaged.
-
When installed correctly, an audible click will be heard and the pressure sensor will not be able to be removed from its bracket without
disengaging the retaining tab.
6. Slide the OCSM into the seat cushion pan bracket and install the rivets.
-
The OCSM must be correctly positioned and securely fastened in place. Failure to do so can set a DTC in the RCM.
7. Position the foam pad to the seat cushion pan.
8. NOTICE: Inspect the seat cushion pad and seat cushion trim cover for any foreign material, before installing the seat cushion trim cover
to the seat cushion pad. If any foreign material is found, remove it. Failure to follow these instructions may result in incorrect operation
of the Occupant Classification Sensor (OCS) system and may cause system failure.
Install the seat cushion trim cover to the seat cushion foam pad and attach the J-clips.
9. NOTICE: Inspect the seat cushion pad and seat cushion trim cover for any foreign objects, before installing the seat cushion trim cover to
the seat cushion pad. If any foreign objects are found, remove them. Failure to follow these instructions may result in incorrect operation
of the Occupant Classification Sensor (OCS) system and may cause system failure.
Position the seat cushion and pan assembly to the seat track.
-
To aid in installation, recline the seat backrest.
10. Install the 4 seat track-to-cushion frame bolts.
-
Tighten to 25 Nm (18 lb-ft).
11. Connect the electrical connectors and wiring clips.
1. Connect the OCSM electrical connector.
2. Connect the pressure sensor electrical connector.
3. Install the 2 wiring clips on the wiring harness to the seat cushion pan.
4. If equipped with heated seats, connect the heated seat relay electrical connector, install the wiring clip on the wiring harness to the seat cushion
pan, and connect the 2 cushion heater mat electrical connectors.
