Escape 2WD V6-3.0L (2009)
Starter Motor: Service and Repair
Starter Motor - 3.0L
Removal and Installation
1. Disconnect the battery ground cable.
2. Remove the starter motor solenoid wire nut.
-
To install, tighten to 5 Nm (44 lb-in).
3. Remove the starter motor solenoid battery cable nut and position aside the cables.
-
To install, tighten to 12 Nm (106 lb-in).
4. Remove the ground wire nut and position aside the ground wire.
-
To install, tighten to 18 Nm (159 lb-in).
5. Remove the 2 stud bolts and the starter motor.
-
To install, tighten to 27 Nm (20 lb-ft).
6. To install, reverse the removal procedure.
