Escape 2WD V6-3.0L (2009)
Removal
NOTICE: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may result
in major service expense. New parts must be installed with the same part numbers or equivalent part, if replacement is necessary. Do not use a
replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure correct
retention of these parts.
1. Remove the wheel and tire.
2. NOTE: Apply the brake to keep the halfshaft from rotating.
Remove and discard the wheel hub nut.
3. Remove the wheel speed sensor ring.
4. Remove the brake drum.
5. Using the Front Hub Remover and Impact Slide Hammer or equivalent tools, remove the wheel hub.
