Escape 2WD V6-3.0L (2009)
13. Remove the main control transaxle separator plate.
14. Remove the 2 bolts and separate the solenoid body from the main control valve body.
Installation
1. Install the solenoid body onto the main control valve body. Install the 2 bolts.
-
Tighten to 10 Nm (89 lb-in).
2. NOTE: If cleaning the main control assembly or inspecting the valves, refer to Main Control Valve Body See: Valve Body/Service and
Repair/6F35 Main Control Valve Body. If installing a new main control assembly, continue with this procedure.
Position the OSS and TR sensor wiring harnesses aside and install the main control-to-transaxle case separator plate.