Escape 2WD V6-3.0L (2009)
7. Install the transmission fluid drain plug.
-
Tighten to 12 Nm (106 lb-in).
3.0L engine
8. Drain the cooling system.
9. Disconnect the upper radiator hose from the coolant pump housing and position it aside.
10. Disconnect the lower radiator hose from the thermostat housing and position it aside.
All vehicles
11. Disconnect the selector lever cable end from the manual control lever.
12. Remove the nut and the manual control lever.
13. Disconnect the transaxle electrical connector.
14. Remove the transaxle electrical wiring harness retainers from the transmission fluid pan studbolts.
