Escape 2WD V6-3.0L (2009)
Transmission Speed Sensor: Service and Repair
Turbine Shaft Speed (TSS) Sensor
6F35
Turbine Shaft Speed (TSS) Sensor
Removal
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the retainers and the LH splash shield.
3. Disconnect the Turbine Shaft Speed (TSS) electrical connector, remove the bolt and the TSS sensor.
Installation
1. Install the TSS sensor, the bolt and connect the TSS electrical connector.
-
Tighten to 12 Nm (106 lb-in).
2. Install the LH splash shield and the retainers.
3. Fill with clean transmission fluid to the correct level.
